Yashica 635 User Manual page 5

4. Pull out the lower Spool Stud
Knob and place a new roll of film
(standard 120 roll film) into position
in the lower Film Chamber.
4www.bu t kus.org
5. Pull the film leader gently and
insert it into the slot on the Take-up
Spool in the upper Film Chamber.
Make sure the film leader is inserted
into the wider one of the two slots
and its edge is set flush against the
spool flange.
6. Turn the Film Advance Knob
until the arrow "start" mark on the
film leader aligns with the triangular
mark on the edge of the picture
frame. Then close the Back Cover.
7. To lock the Back Cover, press it
against the camera body and turn the
Back Cover Release Ring in the
direction of "C" (Close).
8. In the course of film loading, the
Exposure Counter automatically resets
to "S" (start) position.
9. Therefore, wind the Film Advance
Knob until the figure "1" appears in the
Exposure Counter Window.
10. After making an exposure, push the
Film-stop Release (20) and wind the
Film Advance Knob. The Exposure
Counter will register the number of
exposed frames and the Film Advance
Knob will lock automatically.