Technical Data; Installation - Zanussi ZRB935NX2 User Manual

7. Open the door. Make sure that the lamp
comes on.
1

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the am-
bient temperature corresponds to the climate
class indicated on the rating plate of the appli-
ance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
www.zanussi.com
2
Height
Width
Depth
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1850 mm
595 mm
658 mm
18 h
230-240 V
50 Hz
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be positioned
below overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet at the
base of the cabinet.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
13