Starting The Engine; Shutting Off The Engine; Operating The Hopper - Toro MB TX 2500S Operator's Manual

Starting the Engine

1. Engage the parking brake.
2. Engage the choke.
Note:
A warm or hot engine may not require
choking. You may need to repeat the starting
cycle when you start the engine for the first time
after you have filled a completely empty fuel
system with fuel.
Note:
Let the machine stay at low idle for
3 minutes when starting the machine in a
temperature below 30°F.
3. Move the throttle between the F
positions.
4. Turn the key switch to the S
5. When the engine starts, disengage the choke.
Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to start,
allow a 15-second cool-down period between
attempts. Failure to follow these instructions can
burn out the starter.
and S
AST
position.
TART
Figure 9

Shutting Off the Engine

1. Move the throttle between the F
positions.
2. Engage the parking brake.
3. Turn the key switch to the O
remove the key.
LOW

Operating the Hopper

Hopper capacity: 1134 kg (2,500 lb)
Know the load capacity of the machine and never
exceed it. This machine normally operates on uneven,
unpaved, bumpy, and/or inclined surfaces—adjust the
load accordingly.
1. Position the machine where you intend to dump
the load.
2. Turn the hopper left or right by pushing the left
or right side of the swivel switch.
3. Dump the hopper by pushing the top of the
dump switch.
4. Lower the hopper by pushing the bottom of the
dump switch.
Note:
0.2 to 1.3 seconds, the hopper fully lowers
automatically.
g038313
14
FF
Figure 10
If you hold the bottom of the switch
and S
AST LOW
position and
g038314