Vista 1093 Installation Instructions

INSTALLATION INSTRUCTIONS
WARNING: Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC) and local codes. For portable stake or
surface mount using a cord and plug, the luminaire must be plugged into a receptacle protected by a ground fault circuit interrupter (GFI). Failure to
do so may result in serious injury and/or damage to the luminaire.
MAINTENANCE: To assure proper operation and efficiency and to prevent luminaire overheating, lens must be kept clean and free of dirt, dust,
leaves, trash and mineral deposits from water. A regular schedule maintenance program is recommended.
SAFETY WARNING: Luminaire can become very hot depending on the lamp wattage used. Lens and housing around the lamp can become hot
enough to blister hands. Particular care should be taken not to locate luminaires where small children can reach them if high wattage lamps are
used.
NOTE: Always use UL recognized wire connectors for connections.
NOTE: Save these instructions for future reference.
LUMINAIRE IS UL LISTED FOR ABOVE GRADE INSTALLATION ONLY.

LUMINAIRE MOUNTING:

1. Make sure electrical supply is off at circuit breaker before starting
luminaire installation or servicing luminaire.
2. Thread luminaire onto junction box or other mounting device until it is
at desired direction using thread sealant. Tighten jam nut (provided) to
ensure the luminaire is locked to adjusted position.
3. Attach luminaire leads to line in leads observing polarity, black to
black, white to white and green to ground using silicone filled safety
connectors (provided).
4. Attach junction box cover with luminaire to junction box (by others).
Make sure not to pinch wires that may be sandwiched between cover
and box.
5. Coat exposed luminaire threads with thread sealant to keep moisture
from entering junction box or other mounting device.
6. To adjust luminaire aiming angle, loosen adjustable knuckle screw. Do
not disengage totally. Hold luminaire at selected angle and tighten
knuckle screw firmly.
7. Install lamp.
8. Coat all exposed screws with silicone grease.
9. Supply power to the luminaire and check for proper operation.
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.
1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • email@vistapro.com • www.vistapro.com
Lamp Information
Cat No
1093
Incandescent or HID
Shroud
Housing
1093
Architectural Series
Up & Accent Lights
Lamp Type Max Watts
R30, PAR30
Adjustable
knuckle
1/2" NPT
75
Shroud
screw