Installation - Mechanical; Lifting And Rigging; General Lifting Considerations - Trane Climate Changer TCFS Nstallation, Operation, And Maintenance

Installation - Mechanical

Lifting and Rigging

General Lifting Considerations

WARNING
Risk of Unit Dropping!
Always place, assemble, and suspend modules/
subassemblies one at a time. Placing, assembling, and/
or suspending more than one module/subassembly at
a time could result in module/subassemblies dropping
and crushing technicians which could result in death,
serious injury, or equipment damage.
WARNING
Improper Unit Lift!
Failure to properly lift unit could result in unit dropping
and possibly crushing operator/technician which could
result in death or serious injury, and equipment or
property-only damage. Test lift unit approximately 24
inches to verify proper center of gravity lift point. To
avoid dropping of unit, reposition lifting point if unit is
not level.
NOTICE:
Equipment Damage!
Keep skid in place until unit is ready to set. Do not
move the unit or subassembly without the skid in
place as shipped from the factory. Premature skid
removal could result in equipment damage.
Before preparing the unit for lifting, estimate the
approximate center of gravity for lifting safety. Because of
placement of internal components, the unit weight may be
unevenly distributed, with more weight in the coil and fan
areas. Refer to the unit submittals for section weights. Test
the unit for proper balance before lifting.
For outdoor air handlers, preparation of the roof curb or
pier mount and roof openings must be completed before
lifting to the roof. Refer to curb manufacturer's installation
instructions for more details.
12
WARNING
Heavy Objects!
Ensure that all the lifting equipment used is properly
rated for the weight of the unit being lifted. Each of the
cables (chains or slings), hooks, and shackles used to
lift the unit must be capable of supporting the entire
weight of the unit. Lifting cables (chains or slings) may
not be of the same length. Adjust as necessary for even
unit lift. Other lifting arrangements could cause
equipment or property damage. Failure to follow
instructions above or properly lift unit could result in
unit dropping and possibly crushing operator/
technician which could result in death or serious injury.
See unit submittal drawings for correct placement of
sections. Always rig subassemblies or sections as they
ship from the factory. Never bolt sections together before
rigging.
• Lift all sections individually using all lifting lugs
provided. See specific instructions for handling the
pipe cabinet if shipped separately
Cabinets, " p. 13).
Figure 3. Recommended attachment to lifting lugs.
("Hoods and Pipe
Grade 9
bolt
CLCH-SVX010A-EN