Operating The Sprayer; Disassembly And Reassembly - Craftsman CMXCAFG190643 Instruction Manual

OPERATING THE SPRAYER

Filling
Fill the tank to the desired level.
1a. REMOVE PUMP: Turn handle counter-clockwise
2a. INSTALL PUMP: Turn handle clockwise until tightly sealed
on tank
1a
Pressurizing
Make sure the shut-off trigger is not locked in the "in use"
position
1b. Push down on the handle and turn counter-clockwise to
unlock the handle.
2b. Pump handle in a smooth up and down motion until
pressure builds up.
3b. Push down on handle, turn clockwise to lock into place.
1b 2b
Spraying and Locking
1. Squeeze shut-off trigger to begin spraying.
2. Release shut-off trigger to stop spraying.
3. For continuous spraying, squeeze the trigger and slide
into locked position as shown.
Finish
1. Depressurize
a. Lay tank on its side with the hose outlet on the
bottom. Direct nozzle away from face and body and
squeeze the shut-off handle until unit stops spraying.
This will release the pressure in the tank.
2. Turn the pump handle counter-clockwise to remove
pump.
3. Empty any remaining liquid according to the product
disposal directions.
4. Follow cleaning instructions.
2a
3b
Cleaning
1. Fill the tank with clean tap water. Replace the pump
and tighten securely.
2. Agitate the tank to rinse the chemicals from the tank
and pump.
3. Remove the pump and empty the contents according
to the product disposal instructions.
4. Refill the tank with clean tap water.
5. Make sure the pump is free of dirt and debris, and
re-install into the tank. Tighten securely.
6. Pressurize the tank as described in the pressurizing
section.
7. Direct the nozzle away from yourself and squeeze the
shut-off trigger for at least 30 seconds to clean the hose
and shut-off.
8. Release pressure as described in the finishing section.
9. Remove the pump and empty contents according to
the product disposal instructions.
10. Repeat steps 1-9 until thoroughly cleaned.
Sprayer Storage
1. Sprayer tank should be hung upside down, with the
pump removed.
2. Do not store or leave any solution in tank after use.
3. Store in warm, dry location out of direct sunlight.
4. Keep sprayer and all chemicals out of reach of children.
Disassembly & Reassembly
1. Remove pump from tank.
2. Squeeze tabs that lock cap and pull to unlock.
3. Remove handle, lubricate o-ring as required.
4. Replace pump cap, align tabs on pump cap and barrel,
and push down until tabs lock into place.
English
3