PUTCO 1951 Series Instruction Manual

Molle panels; ford f-series

INSTRUCTION GUIDE

Congratulations on your purchase of a high quality PUTCO

you need any application or technical assistance, feel free to call us at:

Monday-Friday 8:00am - 5:00pm (Central Standard Time)

Contact your PUTCO

PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION

AND CHECK TO SEE THAT ALL PARTS ARE INCLUDED

REQUIRED TOOLS

3/16" HEX KEY

10MM WRENCH

FORD F-SERIES

1-800-247-3974

dealer for other quality accessories.

T30 TORX DRIVE

DESCRIPTION

Molle Front Plate

Molle Front Side Plates

Molle Rear Side Plates

M6 Bolts

Rubber feet

Jam nuts

Brackets

Button Head Bolt – 2-3/8" Long

Well Nut – 5/8" Outer Diameter

product. Should

QT Y

0-7

1951XXI

Table of Contents

Do you have a question about the 1951 Series and is the answer not in the manual?

Page 1 INSTRUCTION GUIDE FORD F-SERIES Congratulations on your purchase of a high quality PUTCO product. Should ® you need any application or technical assistance, feel free to call us at: 1-800-247-3974 Monday-Friday 8:00am - 5:00pm (Central Standard Time) Contact your PUTCO dealer for other quality accessories.
Page 2 MOLLE Panels Instruction Guide INSTALLATION INSTRUCTIONS Unscrew and remove the 4 tie-down plates using a T30 Torx driver. Place the side mounting brackets behind the tie down plates, then fasten to the bed re-using factory hardware. (NOTE: for the 6.5ft Super Duty molle the front side plate bracket is larger than the one for the rear). Unscrew and remove the 2 rear tie-down hooks using a T30 Torx driver.
Page 3 MOLLE Panels Instruction Guide Fasten the molle plates to their brackets using the supplied M6 bolts and a T30 Torx driver. Side Plate Assembly Front Plate Assembly Adjust the rubber feet on the front plate down until they are snug against the floor of the bed. Secure the rubber feet in place by tightening the jam nuts against the nutserts using a 10mm wrench.