Step 6: Switch On Sounder - Abus Secvest FUSG50101 Installation Instructions And User Manual

Step 6: Switch on sounder

Danger
The sounder should not be activated in the following steps. You should, however, be prepared for
the fact that the sounder might nevertheless be activated. Make sure that any loud sounds emitted
do not startle you, causing you to fall off the ladder.
• Connect the batteries.
The sounder should switch on in "silent start mode", which is indicated by the fact that the
comfort LEDs are permanently on.
Important
Insert the battery cables in the guides provided. Otherwise, the cables may be crushed.
• Put the jumper/connector cover back on, close the lid, tighten the cover fixing screws and
close the screws' covers.
Ten seconds after closing the cover, the comfort LEDS will flash alternately to indicate that
the sounder is ready. If activated, see the operation of the comfort LEDs chapter. (If you
open the cover again, the sounder will activate itself.)
• Test the system fully.
• Exit installer mode on the alarm panel. The system is now ready.
Note
Test the sounder using the panel in installer mode.
• Housing is open (tamper switch open).
Only the flashing LEDs turn on in this configuration. The acoustic piezo sounder therefore
does not emit a tone.
• Housing is closed (tamper switch closed).
The flashing LEDs turn on and the acoustic piezo sounder emits a tone in this configuration.
Installation
45 | EN