Assembly - Ryobi PBF100 Operator's Manual

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-
pretation of these symbols will allow you to operate the product better and safer.
SYMBOL
V Volts
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
SYMBOLS
NAME
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute

ASSEMBLY

5 – English
DESIGNATION/EXPLANATION
INSTALLING/ADJUSTING THE AUXILIARY
HANDLE ASSEMBLY
See Figure 1, page 8.
An auxiliary handle is included for ease of operation and to
help prevent loss of control. The handle can be mounted for
left or right hand use.
To install:
 Position the handle for right or left handed use.
NOTE: You may have to spread the handle slightly to
allow it to slide over the base.
 Align the screw through the hole and into the base of the
polisher.
 Choose the position that you find most comfortable.
 Use the included hex key to securely tighten the screw.
 Repeat for other side.