Changing Default Settings - Epson FX-880+ Quick Manual

Changing default settings

Follow these steps to enter the
default-setting mode and change the
printer's default settings:
Note:
❏ To print the language selection and
default-setting mode instructions, you need
three sheets of A4 or letter size single-sheet
paper or three pages of continuous paper that
is at least 279 mm (11 inches) long and 210
mm (8.3 inches) wide. See "Continuous
Paper with the Pull Tractor" and "Single
Sheets with the Paper Guide" for
instructions on loading continuous paper
and single sheets.
❏ If you use single sheets, you need to load a
new sheet of paper each time the printer ejects
a printed sheet from the paper guide.
1. Make sure paper is loaded and the
printer is turned off.
c
2. Turn on the printer while holding down
the Font button.
The printer enters the default-setting
mode and prints the language selection
instructions (one page).
3. Press the Font button until the Font and
Pitch lights indicate the language you
want, as described in the language
selection instructions.
4. Press the Tear Off/Bin button to print the
default-setting mode instructions (two
pages) in the language you selected.
Downloaded from: http://www.usersmanualguide.com/
Caution:
Whenever you turn off the printer,
wait at least five seconds before
turning it back on; otherwise, you
may damage the printer.
EPSON FX-880+/FX-1180+ Quick Guide
The printed instructions list the settings
you can change, describe how to change
them, and show you how the control
panel lights help you make settings. Use
these instructions to change the printer's
default settings from the control panel.
Note:
The arrows in the instructions indicate the
printer's current settings.
5. When you finish making settings, turn
off the printer and exit the
default-setting mode.
Note:
You may exit the default-setting mode by
turning off the printer at any time. Any
settings you have made remain in effect until
you change them again.
Default Settings (4/4)