Epson FX-880+ Quick Manual page 20

Single Sheets with the High-Capacity Cut-Sheet Feeder
The high-capacity cut-sheet feeder holds up
to 150 sheets of paper or up to 25 envelopes.
Note:
It is recommended that you close the flap on the
front cover if paper is not loaded from the front slot.
Follow these steps to load paper in the
high-capacity cut-sheet feeder:
c
Caution:
Do not load multipart forms, carbon
paper, or labels in the high-capacity
cut-sheet feeder.
1. Set the paper release lever to the
single-sheet position. Also make sure the
paper-thickness lever (located under the
printer cover) is set to 0 if you are using
ordinary single-sheet paper. (If you are
using envelopes, see "Special Papers"
for instructions on setting the
paper-thickness lever.)
Downloaded from: http://www.usersmanualguide.com/
EPSON FX-880+/FX-1180+ Quick Guide
2. Pull the lock levers on the edge guides
forward to release them.
3. Slide the left paper guide until it is
aligned with the triangle mark; then lock
it in place by pushing back its lock lever.
Next, slide the right paper guide to
roughly match the width of your paper.
Slide the paper support to midway
between the paper guides.
Single Sheets with the High-Capacity Cut-Sheet Feeder (1/2)