Table of Contents
Advertisement
Chapter 3 - Commissioning
Configuring the Transmit Power of
the A
U-RE-2.4
The transmitted output power of the AU-RE-2.4 should be adjusted in
the following cases:
If there is a need to cover a relat
the interference with the operation of units in neighboring cells.
According to the FCC rules 15.247 (3), when operating the
equipment in a multi point system, the RF output power must be
adjusted according to the gain of the antenna to limit the EIRP to a
maximum of 36 dBm.
Table 3-6 displays the required value of the Transmit Power Control
pa
rameter for FCC approved antennas.
NOTE
According to FCC Rule 15.204 ©, only antennas authorized as part of the FCC grant
may be used with this product.
For compliance with IC&FCC requirements, the maximum allowed output power in units
operating in HDM Mode is 19 dBm. Therefore, when using an antenna with a net gain of
17 dBi or lower, the Transmit Power Control parameter should be set to the maximum
value for an output power that does not exceed 19 dBm. These values are identified
clearly in the appropriate locations in the tables.
Table 3-6: Required Value of Transmit Power Control Parameter for 2.4 GHz FCC
Antenna
SECT 17V-60
SECT 16V-90
UNI-16
UNI-24
UNI-9
OMNI-8
* The net gain of the antenna kit includes the loss of the RF cable included in the
kit (if applicable).
3-16
Approved AU Antennas
Net Gain*
Transmit Power
Control Parameter
16.5
10
17.5
9
15.5
10
23.5
7
7.5
15 (10 for HDM)
7.5
15 (10 for HDM)
ively small area while minimizing
Output Power to
Antenna Port
19
17
19
12
26.5 (19 for HDM)
26.5 (19 for HDM)
Cell Extender System Manual
Advertisement
Table of Contents
