Table of Contents
Advertisement
4. Insert and crimp the RJ-45 connector. Refer to
instructions on preparing the cable.
5.
Connect the Ethernet cable to the RJ-45 connector.
6. Replace the service box
external jack of the cab
a good seal.
NOTE
In unused Ethernet connection service boxes, a sealing metal disk must be in place
inside the top nut to ensure proper protection against rain and moisture.
To connect the power cable:
1. Connect the power cable to the AC mains.
2.
Seal the pow
entry of insects.
To connect the Ethernet port to a local Ethernet equipment
NOTE
The Ethernet port of the local Ethernet equipment, such as a PC or a hub, must be
configured manually to operate at 10 Mbps, half-duplex. Auto-Negotiation may not work.
1. Remove the two screws holding the ETHERNET service box to the
unit and remove the service box.
2. Unscrew the top nut from the service box. If there is a sealing metal
disk inside, remove it.
3. Route the uncrimped end of a Cat. 5 Ethernet cable (8-wire, 24
AWG) through both the top nut and the service box.
Manual Revision 1.0
and then the top nut. Make sure that the
le is well inside the service box to guarantee
er cable conduit at the AC mains end to prevent the
Installation Requirements
Appendix B
for
2-19
Advertisement
Table of Contents
