Table of Contents
Advertisement
Chapter 2 - Installation
Two poll mounting kits for the radio units
98 ft. (30 m) RG 58 IF cable with TNC connectors
98 ft. (30 m) Category 5 Ethernet cable kit
RJ-45 Special Monitor cable
5 ft. (1.5 m) LMR-400 Antenna cable with N-Type connectors
A standard Monitor cable (for configuring the served SUs)
Documentation and Utilities CD
Additional Items Required for the CX Installation
The following items are also required for the installation of the Cell
Extender:
½ inch conduit for the power cable
3 wire fused single phase 100 -240 VAC service (consult a licensed
electrician to install)
Outdoor category 5 Ethernet cable and connectors (if a local
Ethernet connection is required)
An approved AU antenna (see list of approved antennas in Tables
2-2, 2-3 and 2-4 on page 2-7)
Grounding cables and other lightning protection materials
according to specific installation requirements
For configuring basic parameters – a portable PC with Terminal
Emulation software (connected to the equipment using the
appropriate Monitor cable)
OR
A portable PC with Ethernet NIC, an Ethernet cable (straight) and
Telnet software (or BreezeCONFIG ACCESS Configuration Utility).
Refer to for more details regarding applicable methods of
connecting to the equipment for parameters' configuration.
Installation tools and materials, including appropriate means (e.g.
poles) for installing the system components and antennas.
2-4
Cell Extender System Manual
Advertisement
Table of Contents
