Alvarion BreezeACCESS II CX System Manual page 57

Table 3-3: Basic Parameters in 2.4 GHz Units
Parameter
ESSID
Operator ES SID Option (A
Operator ESSID (AU)
Hopping Set (AU)
Hopping Sequence (AU)
HDM Mode (AU)
Manual Revision 1.0
Default Value
ESSID1
U) Enable
ESSID1
Disable
Configuring Basic Parameters
Comment
The ESSID of the SU
module must be the
same as the ESSID of
the Base Station AU.
In CX-BA2.4-BA-2.4 DO
NOT configure the ESSID
of the SU with the
Operator ESSID . A
different ESSID must be
configured in the AU
module.
Modify this parameter to
the same Operator
ESSID of the other AUs.
If you are not using this
parameter, where the
Operator ESSID Option is
disabled, change the
value to something other
than the default.
Not applicable if HDM
Mode is ensbled.
In CX-BA2.4-BA-2.4,
must be the same as
configured for the Base
Station AU.
Not applicable if HDM
Mode is ensbled.
In CX-BA2.4-BA-2.4,
must differ from the
Hopping Sequence
configured for the Base
Station AU
Applicable only to US
FCC hopping standard.
3-7