Table of Contents
Advertisement
Chapter 2 - Installation
Installation Requirements
This section describes all the supplies required to install the Cell
Extender, and the items included in each installation package.
NOTE
Before proceeding beyond this point and installing the Cell Extender, the spectrum
survey should already be complete using the spectrum analysis tool provided with this
equipment (special firmware). The results of the survey will identify the specific clear
channels and polarization required to configure and operate the 900 MHz equipment.
Refer to the BreezeACCESS Spectrum Analyzer User's Guide for detailed instructions
on performing the survey. This step is important to ensure the best performance from
the product.
Packing List for CX-BA2.4-BA2.4 Cell Extender
CX-IDU Interface Unit with a 15 ft. (4.5 m) open-ended power cable
Sun guard for the Interface Unit
Mounting kit for the Interface Unit
SU-RA-2.4 Radio Unit with an integrated 16 dBi antenna
AU-RE-2.4 Radio Unit with a connection to an external antenna
Two poll mounting kits for the radio units
Two 98 ft. (30 m) RG 58 IF cables with TNC connectors
RJ-45 Dual Monitor cable
5 ft. (1.5 m) LMR-400 Antenna cable with N-Type connectors
A standard Monitor cable (for configuring the served SUs)
Documentation CD
Packing List for CX-BA2.4-BA900 Cell Extender
CX-IDU Interface Unit with a 15 ft. (4.5 m) open- ended power cable
Sun guard for the Interface Unit
Mounting kit for the Interface Unit
SU-RA-2.4 Radio Unit with an integrated 16 dBi antenna
AU-RE-900 MHz Radio Unit with a connection to an external
antenna
2-2
Applicable to systems with a 900 MHz AU
Cell Extender System Manual
Advertisement
Table of Contents
