Addressright 300 Feeder Control Panel - Pitney Bowes AddressRight 300 User Manual

1. Remove the four rubber feet.
2. Place the feeder on the feeder base to align it with other inline components such as printers and
tabbers. The exit end of the feeder faces the closed end of the base. The feeder's rubber feet fit
into the recesses on top of the base [B].

AddressRight 300 Feeder Control Panel

1. Speed control: Varies the speed of the feeder in either Manual or Auto mode to provide
separation between printed pieces
2. Continuous Feed: When pressed with the feed select switch set to Manual, this allows the
feeder to feed continuously
3. Single Feed: When pressed with the feed select switch set to Manual, this allows the feeder to
feed a single piece of media
4. Batch Counter: Counts the number of pieces run on each job. Can be reset.
5. Feed Select switch: With the feed select switch set to Manual ( ), the operator can feed one or
continuous pieces of media by pressing the Single and Continuous feed switches. When set to
Auto ( ), the interface controls the feeder through an external device.
Pitney Bowes User Guide October 2019 3