Use; Using The Remote Control - Acova Regatta twist air ec 594w coul Instructions For Use Manual

3. Use

EN

3.1 Using the remote control

3.1.1 Commissioning
Pry off the frame (A). Remove the battery insulation tab and reposition the frame.
After the start-up phase, the set time LED
Immediately press the + or - key to set the time on your remote control.
Press and hold the + or - key to speed up the process.
Once the time is set, wait approximately 10 seconds (or press the P1 or P2 key).
The is no longer displayed and the time has been set.
Please follow the instructions below in the event of an incorrect time setting.
3
is displayed and 00:00 blinks.
40005959
SETTING THE TIME
The time can be set by following the procedure below:
o Make sure the remote control is switched on.
o Access the setting function by pressing and holding the P1 and P2 keys
together.
o The set time LED is displayed and 00:00 blinks.
o Set the time by pressing + or -. Press and hold the + or - key to speed up
the process.
o Once the time is set, wait approximately 10 seconds (or press the P1 or P2
key).
o The is no longer displayed and the time has been set.
REPLACING THE BATTERIES
When the low battery indicator light
to replace them (2x1.5V alkaline batteries, type LR03 or AAA; we advise
against using rechargeable batteries).
When the batteries are replaced, all the remote control parameters are saved
(for instance: P1 and P2 programming) except for the time setting.
You should take the following precautions:
- ensure correct +/– polarity;
- take care when disposing of used batteries: protect the environment by
disposing of them at an approved collection point.
3.1.2 Function description
SWITCHING THE REMOTE CONTROL ON AND OFF:
You can switch the remote control on or off by pressing and holding the
NOTE:
Switching off the remote control will put the blower on stand-by.
40005959
is displayed, you have a few days
key.
EN
31