Troubleshooting - Panasonic NR-BD418P Operating Instructions Manual

Pan water evap (Backside of the refrigerator)
Removing
Tilt up the pan water
1
evap a bit and then lift
it upward until the pan
water evap hole
unlocks from the hook
pan water evap.
Pull the pan water evap until it touches
2
with the evap pipe then carefully take it
out under the evap pipe.
●Do not damage or deform the evap pipe.
Requests

Troubleshooting

In these cases?
The refrigerator does not
operate.
The refrigerator does not
cool enough.
Vapor generated inside and
outside the cabinet / surface
of door.
The refrigerator generates
noise.
Food becomes frozen
NR-BD468(EN).indd 15 NR-BD468(EN).indd 15
Attaching
Insert the pan water evap under the evap
1
1 1
2 2
pipe.
Insert the pan water evap hole into the
2
hook pan water evap as well as press-
fitting both sides.
● Check that the plug and wall socket are in good condition.
● Check if there is any problem with the mains fuse or house wiring.
● Check by unplugging for 10 minutes and plugging back in.
● Check to be sure that light in control panel is display at proper
positon (P.6)
● Check to ensure that the refrigerator is not overloaded with
foodstuffs or that hot food have been placed in the refrigerator.
● Is the refrigerator exposed to direct sunlight or a heat source?
● Is the refrigerator door completely closed?
● Is the refrigerator door opened frequently?
● Condensation may appear on the surface of the cabinet when
humidity is high or air circulation around the unit is poor.
● If there is condensation inside, check if the door is completely closed.
Is the refrigerator frequently opened or left open for a long time?
Have any hot foodstuffs been placed inside the refrigerator?
● Check if the refrigerator is located on a stable, level fl oor and is
installed correctly.
Use the adjustable bolt if required to level the refrigerator. (P.4)
● Check if there is any object in contact with the refrigerator.
● Cracking sound within caused by the parts adjusting temperature
which is normal.
● Was the food placed near the cold air duct?
● If the temperature control has been set to "Max" try adjusting the
temperature control to the "Min" setting.
● Has the food been placed in the chilled case?
Once every 3 months
Hook pan water evap
2 2
Check here.
Appendix
2 2
Evap pipe
1 1
15
12/15/16 4:39 PM 12/15/16 4:39 PM