Panasonic NR-BD418P Operating Instructions Manual page 13

Table of Contents

Advertisement

Trays / PC slide glass tray (Made of glass)
Trays
Lift up the back of the tray and pull it
forward. Once the protrusions of the tray
are unhooked from the rails, tilt the tray
and remove it.
Attention
●When removing the tray above the vegetable case, please pull out the vegetable case
fi rst and then follow to removing the tray as above details.
●In case of attaching the tray and it does not lock, make sure that you did not attach it
the wrong tray.
●Trays, the PC slide glass tray are made of glass and heavy. Please handle them with
care so that they do not fall and cause any damage or injury. For attaching trays, hold
them with the protrusion side down and fi rmly insert.
Case (Ag Meat Case)
Removing
Attention
●When pull or attach the freezer case, be sure to grab its handle with upturned hand.
Please refer to the above illustration.
(Otherwise, FC cover case may accidentally hit your fi ngers.)
PC cover cool zone (Extra Cool Zone)
Removing
Lift up the PC cover cool zone and slide
it into the above slot until it reaches the
end of the stopper. Then remove screws
to take off the cover.
Attaching
Insert the PC cover cool zone into its slot
and tightening screws. Then slide it out
and pull the cover down.
●Be sure to grab the cover with upturned hand. Otherwise, your hand may accidentally
hit the refrigerator.
NR-BD468(EN).indd 13
NR-BD468(EN).indd 13
Protrusion
Rail
Glass tray
Pull out the case as far
as possible. With lifting
up the front, pull it out
at an angle with holding
the flap above the case.
Once every 3 months
Unhook the protrusion at the front of
the PC slide glass tray and pull it.
Rear part
Front part
Remove the PC slide glass tray
Unhook the front part by lifting it up
1
slightly.
Slide the front part under the rear part
2
and remove it both.
Fit the rear part of
the PC slide glass
tray so that the hole
on it is towards you.
Once every 3 months
Attaching
With holding up the flap,
lift the back of the case
and install it along the rails
inside.
Once every 3 months
Appendix
PC cover cool zone
Screws
13
12/15/16 5:10 PM
12/15/16 5:10 PM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nr-bd468p

Table of Contents