Brita C150 DIRECT FINEST Installation Instructions

BRITA C150 DIRECT FINEST
INSTALLATION INSTRUCTIONS
Please read carefully and retain for future reference.
CONTENTS
1. Important Informa�on
2. Included Parts
3. Filter Head Assembly Instruc�ons
4. Installa�on Instruc�ons
4.1. Auxiliary Tap Connec�on
5. Plumbing in Your System
6. Replacing the Filter Cartridge
7. Warranty Informa�on
1. Important Informa�on
- For correct opera�on of this appliance, it is essen�al to strictly observe these installa�on and opera�ng instruc�ons.
- Do not use this product with water that is microbiologically unsafe or water of unknown quality without adequate disinfec�on before or
a�er this system.
- Installa�on must comply with any exis�ng State or Local Plumbing codes. Some Plumbing Codes require the installa�on of water filter sys-
tems to be carried out by a licensed plumber.
- For COLD water use only. Maximum temperature 38°C. Minimum temperature 2°C.
- For internal use only.
- The inlet water pressure to this water filter housing must not exceed 900kPa (130psi).
- A cer�fied pressure limi�ng valve not exceeding 650kPa (95psi), dual check backflow preven�on valve must be installed on the inlet line
immediately preceding this water filter housing. This valve is included with this system (see Item 10 in Parts Sec�on).
- We also recommend the installa�on of a water hammer protec�on device to protect the water filter housing and its installa�on. Where
water hammer problems exist, a water hammer protec�on device must be installed. Symptoms of water hammer can be noisy, shuttering
and banging pipes when water consuming appliances are opera�ng or taps are turned off. Should the system not be used for 2 days or more,
flush 1-2 litres of water through the system before consuming the water.
- To ensure the high level of performance and protec�on provided from this water filter system, only use Bombora replacement cartridges
which have a maximum cartridge life of 12 months.
- A�er installa�on, check the output water with a test strip and then test every 6-8 weeks a�erwards to establish your filter life based on your
average use. The TH reading should be below low range (less than 80PPM). If you get a higher reading than this on installa�on, call us to
discuss adjus�ng your bypass setting or restric�ng water flow further. Suggested filter cartridge change is 12 months or when the so�ening
capacity is diminished (over 80 PPM TH), whichever comes sooner.
bomborasupplies.com.au 1300 724 249
PART#C150DIRECT-FINEST
sales@bomborasupplies.com.au