Graco Pulse TLM Instructions Manual page 15

1
F . 12
IG
6. Replace cover (3) and secure it with the
two cover screws (11). Torque cover
screws to 18 to 22 in.-lbs (2.03 to 2.48
N•m) to prevent water leakage into the
TLM electronics.
NOTE: If a torque wrench is not used, verify
there are no gaps under the screw heads and
no gaps under the cover flange. This will
ensure proper compression of the gasket for
a water-tight seal.
7. Press the Display button to synchronize
the TLM's internal clock with the Pulse
software clock. If this is not done, the
TLM will not report at the correct
scheduled times.
3A5411J
3
7
Service
15