HP ProDesk 400 G7 Disassembly Instructions Manual page 2

Item Description
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Hexagon Screw Driver
Crisscross Screw Driver
Electric Iron
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1. Use T-15 screw driver to loose thumb screw and remove access panel.
2. Disconnect ODD power cable and ODD SATA cable from ODD.
3. Press the ODD's latch on ODD cage.
4. Remove the ODD from ODD cage.
5. Remove Front Bezel from chassis.
6. Remove the ODD cage.
7. Disconnect HDD power cable and HDD SATA cable from HDD.
8. Use T-15 screw driver to loose the screws of HDD and remove HDD from HDD cage.
9. Remove HDD cage from Chassis
10. Remove HDD from HDD cage
11. Disconnect all SATA data cables from MB.
12. Disconnect P1 Power cable from MB
13. Disconnect system fan cable from MB.
14. Disconnect Speaker and P2 cable from MB
15. Use PH1 screwdriver to remove system fan from chassis.
16. Disconnect cooler fan cable from MB.
17. Use T-15 screwdriver to loose the screws and remove cooler.
18. Use PH1 screwdriver to loose the screws and remove the fan.
19. Separate the fan from cooler.
20. Remove memory from MB.
21. Rotate the handle and open it up.
22. Remove the CPU from the board.
23. Remove the battery from the system board.
24. Remove Graphic card from MB.
EL-MF877-00
Template Revision C
Last revalidation date 09-May-2018
Notes
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
HPI instructions for this template are available at EL-MF877-01
Quantity
of items
included
in product
Tool Size (if
applicable)
T-15
PH1
QUICK 310
Page 2