Table of Contents
Advertisement
GENERAL OPERATING INSTRUCTIONS
UNPACKING YOUR NEW CR2:
When your package is delivered, check the packaging carefully for signs of rough handling. If your CR2 is
damaged, notify the carrier immediately and request an inspection. Be sure to keep the box, packing inserts,
packing lists and carrier's receipt until the inspector has verified your claim.
PROCHEM'S liability ceases when the carrier picks up the shipment. However, our customer service staff will be
happy to furnish any information needed in connection with the claim and will attempt to expedite a resolution.
PLEASE READ BEFORE OPERATING YOUR NEW CR2:
Read the manual carefully and completely before attempting to operate the unit. This manual has important
information for the use and safe operation of the machine. Keep this manual handy at all times.
This equipment has been engineered and manufactured to provide excellent performance and service.
To ensure that your equipment will continue to perform as intended:
Maintain equipment regularly- following the suggested maintenance schedule provided.
Use only original PROCHEM parts when servicing.
Operate equipment with care.
If additional information is needed, please contact:
PROCHEM 0208 974 1515
All information and specifications printed in the manual are current at the time of printing; however, because of
PROCHEM'S policy of continual product development, we reserve the right to make changes at any time without
notice.
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND
INSTRUCTIONS WILL VOID THE WARRANTY.
WARNING!
The machine was designed for use on hard surfaces and carpet and upholstery applications (using optional
accessories) as per instructions and recommendations written in this manual. Any deviation from its proper use
or purpose and the consequential damage that may occur is the sole responsibility of the end user.
Disconnect the power cord from the outlet before servicing. Do not leave machine connected to an electrical
outlet when unattended.
Do not immerse or use this machine in standing water. Such use may cause electric shock.
When using an extension cord, use only a 3-prong conductor grounding cord-12 gauge wire or heavier.
To avoid electric shock, do not expose the unit to rain or snow. Store it indoors in a heated location only.
Do not use the machine for dry vacuuming.
Use defoamer at all times to prevent damage to the vacuum motor.
Do not use water in excess of 76°C in the solution tank.
To prevent seal damage and chemical build-up to the pump system, run clean water through the solution lines
after each day's use.
Use only cleaning chemical products and defoamer recommended by Prochem Europe. Do not use dyes,
bleaches, ammonia, or other additives.
The use of powdered cleaning solution, if not diluted properly, may result in damage to the pump. Powdered
chemical is not recommended. If powdered chemicals are used, premix in a separate container before placing in
the solution tank.
Always read and understand the chemical SDS (Safety Data Sheet) before use.
This equipment is not designed to handle or use combustible/volatile substances such as gasoline or kerosene,
in, on, or near the machine. The use of such materials will cause extreme hazardous condition.
Do not expose machine to freezing temperatures
CR2 Manual 2/1/18
Page 9 of 29
Advertisement
Table of Contents
