Table of Contents
Advertisement
How to program the (sms) text message
You can now change the alarm message to one of your choosing.
To change the message send the text command as follows.
#MESS1=YOURMESSAGE#
#MESS2=YOURMESSAGE#
The default message is ALARM 1 and ALARM 2
Note - You can only use a maximum of 16 characters including spaces for your customised
message.
Telephone call alerts
The auto dialler can be programmed to send you a telephone call after each text alarm has
been sent.
You will receive approximately three ring tones, the unit will then hang up automatically. This
is to prevent call charges being incurred.
To set call alerts to ON please send the text message
#CALL=ON#
The unit will reply back "call on"
To disarm call alerts please send the text message
#CALL=OFF#
If the call function has been set to on you will receive a text message and shortly after a phone
call.
- This sets your custom message to input 1
- This sets your custom message to input 2
Page 7
Advertisement
Table of Contents
