G.S.M Activate AUTO DIALLER PLUS Manual page 12

Inputs 1 & 2
Alarm Input
This is triggered by a negative pulse eg: pulled to the ground for a period of not less than one
second. Before this can be triggered you must activate the alarm input by sending the text
command as follows. The units will need manually activating again once triggered via text
message.
#ALARM=ON# This will activate the alarm if the input is pulled to the ground. You will
receive a text message reading ALARM TRIGGERED
#ALARM=OFF# This will deactivate the alarm. Pulling the input to the ground will have NO
Inputs 1 & 2 - Automatically Reset
They are triggered by a negative pulse eg: pulled to
the ground for a period of not less than one second.
The image (to the left) is a typical application of how
to connect the unit to an alarm panel.
Input 1 and Input 2 are constantly monitored by the
auto dialler and will react immediately when an input
is pulled to the ground
The inputs will auto reset automatically when the
input triggers are cleared/ reset. The Auto-Dialer will
then be ready for the next trigger input.
Alarm Input - Manual Reset
Page 12