Table of Contents
Advertisement
Temperature Monitoring
The Auto dialler has its own temperature sensor which can monitor temperatures from -30 up
to +99 degrees centigrade. Additionally you can monitor temperatures at -40 and -50 degrees
centigrade.
The temperature sensor can be used in two ways.
1: To read the current temperature. Please refer to example one.
2: To be notified when a temperature setting has been reached. Please refer to example two.
Example One
At any time you can get a temperature report from the unit by sending the text command
#READ#
You will receive a text acknowledgement with the current temperature.
Example (hash) (plus or minus symbol) (temperature) (settemp) (hash)
To activate the temperature alarm please send the text message command following the
example below
+
#
32SETTEMP#
-
#
20SETTEMP#
This will set the alarm for minus (-) 20 degrees centigrade.
NOTE
If you need further alerts you will need to repeat example two after receiving a temperature
Alert.
When the temperature hits the designated alarm temperature it will send you a text message
with the current temperature reading and it will also activate relay 2 for 30 seconds
This will set the alarm for plus (+) 32 degrees centigrade.
Page 10
Advertisement
Table of Contents
