Table of Contents
Advertisement
PCB Reference
IMPORTANT - PLEASE READ
PLEASE MAKE SURE YOU DISCONNECT THE POWER FROM POWER INPUT AND
REMOVE THE BATTERY LINK WHEN YOU FIT THE SIMCARD AND YOU PLACE THE
SIMCARD WITH THE CLIPPED CORNER FACING OUT WARDS.
PLEASE SEE PICTURE ABOVE.
Signal LED (blue) - The
blue
LED flashes once per second to indicate when a signal has
been found
Ready LED (green) - The
green
LED will come on when the unit is ready for operation
Charger LED (red) - When the
red
light is on it indicates that the battery is in charging mode.
Battery Link - remove to disconnect battery from use
Dipswitch
1 - If Dipswitch 1 is set to the OFF position it will ONLY search for a 2G signal on startup.
2 - If Dipswitch 1 is set to the ON position it will search for a 3G signal on start up.
Dipswitch 2
Is not used on this model
Advertisement
Table of Contents
