Table of Contents
Advertisement
Installation
Pos: 8.1 /Überschriften/1/M - O/Montage @ 0\mod_1140519732218_3101.doc @ 3159
3
Installation
Pos: 8.2 /Überschriften/1.1/1-spaltig/A - C/Antriebskontrolle @ 10\mod_1181632527031_3101.doc @ 103415
3.1
Actuator check
Pos: 8.3 /Montage/Aktorik/Linearantriebe/Allgemein/Antriebskontrolle @ 10\mod_1182147634156_3101.doc @ 107239
Before you start to install the actuator make sure that the delivery status corresponds to the
ordered status and to the intended use.
•
Check the oil level when installing the device in positions other than IMV 1.
•
Did you fasten the separately delivered venting plug (spare part no. 9287338) in the
uppermost bore (depending on the mounting orientation)?
•
Make sure that the motor and the connection chambers are free of dirt, moisture and
corrosion.
•
Make sure adequate travel is provided for the valve stroke.
Pos: 8.4 /Überschriften/1.1/1-spaltig/D - F/Einbaulage @ 3\mod_1158651041937_3101.doc @ 41702
3.2
Mounting position
Pos: 8.5 /Montage/Aktorik/Linearantriebe/Allgemein/Einbaulage Beschreibung @ 18\mod_1203676956187_3101.doc @ 164547
The gears of the actuator RSD10 ... 200 (Contrac) are oil lubricated. They contain the max. oil
quantity when leaving the manufacturer. Once the actuator is installed replace the uppermost
check plug by the separately supplied venting plug.
Pos: 8.6 /Überschriften/1.1.1/1-spaltig/RSD10 / RSD20 @ 18\mod_1203677004421_0.doc @ 164570
3.2.1
RSD10 / RSD20
Pos: 8.7 /Montage/Aktorik/Linearantriebe/Allgemein/Einbaulage Zeich. RSD_RSDE 10/20 @ 10\mod_1181901153375_3101.doc @ 106675
Fig.3
1 Inspection plug
2 Venting plug
Pos: 8.8 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
12
RSD10 ... 200 (Contrac)
42/68-285-EN
Advertisement
Table of Contents
