Electrical Connection; Cable Shield; Signal Part - ABB RSD Series Operating Instructions Manual

Electrical connection

Pos: 10.1 /Überschriften/1/D - F/Elektrischer Anschluss @ 0\mod_1140620471687_3101.doc @ 3143
4 Electrical connection
Pos: 10.2 /Elektrischer Anschluss/Aktorik/Antriebe/Allgemein/Elektrischer Anschluss @ 16\mod_1197274093609_3101.doc @ 145053
Each actuator requires a Contrac electronic unit which is loaded with the type specific-software.
Carefully consider the instructions for the electronic unit and compare the data labels of the
actuator and the electronic unit in order to ensure a proper hard- and software assignment.
Pos: 10.3 /Überschriften/1.1/1-spaltig/J - L/Kabelschirm @ 10\mod_1181823716656_3101.doc @ 106187
4.1

Cable shield

Pos: 10.4 /Überschriften/1.1.1/1-spaltig/Signalteil @ 10\mod_1182501083765_3101.doc @ 108573
4.1.1

Signal part

Pos: 10.5 /Elektrischer Anschluss/Aktorik/Antriebe/Allgemein/Kabelschirm Anschluss @ 10\mod_1181823021906_3101.doc @ 106144
Fig. 6: Fitting the shield
1. Remove approx. 2 cm of cable sheathing (3) from the end of the cable.
2. Separate the shield and peel it back to its inner sheathing (4).
3. Push the cable through the cable gland and fasten with clamp (1).
4. Make sure that the shielding is touching the clamp and the electronic unit housing (2).
Pos: 10.6 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
16
1
3
2
RSD10 ... 200 (Contrac)
2
1
4
3
42/68-285-EN
M00307