Balance Bike Assembly - Joovy Bicycoo Mg Instruction Manual

Balance Bike Assembly

Assembling and Using your Balance Bike
To ensure safe operation of your balance bike, please follow these instructions carefully.
Unpacking the Balance Bike
• Carefully remove all parts from the box and polybag.
• Identify the parts: body with wheels and seat installed, handlebar, 4mm/5mm Allen wrench.
• Remove the plastic coverings from any areas of the product and discard.
• Discard all packaging materials properly.
• DO NOT allow children to play with any packaging materials.
I WARNING:
Tools Required (included): 4mm/5mm Allen wrench.
Installing the Handlebar
• Keep children away while assembling.
• Use the 4 mm (smaller end) of the Allen wrench to loosen the four bolts of the handlebar bracket
by turning them counter clockwise. (1)
• Remove the bracket cover, being careful not to lose the four bolts. (2)
• Place the handlebar into the bracket as shown in figure. (3)
• Place the bracket cover over the handlebar and locate the holes in the cover with the holes in the
bracket. (4)
• Replace the four bolts through the holes in the bracket cover and bracket (5) and firmly tighten the
bolts clockwise. (6)
• Pull up on the handlebar to make sure it is secure.
NOTE: The handlebar can be adjusted for different heights of a rider by slightly loosening the
bolts, rotating the handlebar to a new position and then retightening the bolts.
I WARNING:
1
6
Adult assembly is required for this product
DO NOT allow children to adjust the handlebar.
2