Table of Contents
Advertisement
Transmission
115. Oil the intermediate shaft bearings.
116. Push the intermediate shaft in carefully in the
crankcase so that the intermediate shaft's gear
wheel does not damage the bushings in the
block. Use tool 999 4030.
38
117. Fit the front sealing flange (and positioning plate)
with a new gasket. The tightening torque is 10
Nm (1.0 kpm) (8.0 lbf. ft.). Then torque tighten the
screws for the sump. The tightening torque is 10
Nm (1.0 kpm) (8.0 lbf.ft.).
Then check the intermediate shaft's axial clear-
ance. The clearance is 0.20–0.46 mm (0.0079–
0.0181 in.).
118. Fit the crankshaft seal with tool 999 5024. Lubri-
cate the seal's rubber lip before fitting. If the spa-
cer tube on the crankshaft has not been removed
the position for the sealing ring is to be changed
so that a new contact surface against the tube is
obtained. Be careful when fitting the seal so that
the rubber lip is not damaged and that the spring
does not jump out of position.
Hide quick links:
Advertisement
Table of Contents
