Volvo Penta AQ145A Workshop Manual page 53

167. Fit the oil dipstick sleeve in the crankcase.
NOTE! The bracket for the ignition coil is to be fit-
ted on the flywheel cover's upper side in the exis-
ting screw holes. (Screw diameter 5/16 UNC
length 19 mm) (3/4"). Then fit the ignition coil and
the cable loom. Connect all the cables and clamp
the cable loom in position.
168. Lay the gaskets for the induction pipe in position.
Fit the induction pipe with the lifting eye on the
rear studs. Tighten the nuts with a torque of 20
Nm (2 kpm) (14.8 lbf. ft.). Fit the oil dipstick sleeve
in the induction pipe.
169. AQ145. Fit the carburetors to the induction pipe.
Fit the throttle rod between the carburetors. Use
new gaskets.
AQ125. Fit the carburettor to the induction pipe.
Use new gasket. NOTE! On engines having main
jet (165) and venturi jet (190) installed, a spacer
washer with a gasket on each side must be instal-
led between the carburetor and the inlet manifold.
170. Fit the fuel pipe between fuel pump and the car-
buretor. Make sure that all sealing washers are
fitted.
171. AQ145. Fit the rubber rings and place the air filter
on the carburetors and also fit the induction silen-
cer.
AQ125. Fit the rubber ring, the air filter and the
cover on the carburetor. Connect the hose (1)
between the fuel pump and the carburetor. Even
AQ145.
172. Close all drain cocks. Replenish the oil and the
water in the engine. See the instruction book for
oil quality and viscosity.
Test run the engine and carry out all the neces-
sary checks which are stated for delivery service
in the warranty certificate.
51