Forward-Facing Installation With Lower Anchor Connectors - Evenflo Sonus Owner's Manual

Forward-facing Installation with
Lower Anchor Connectors (cont.)
Know Your Lower Anchor
3
Connector Assembly
The lower anchor connector assembly that comes with
your child restraint will be one of the two types below.
SecureRight
Adjuster
Hook
Refer to your vehicle owner's manual to locate the lower anchor bars
on your vehicle seat. Attach the right hook, or clip, to the right anchor
bar and the left hook, or clip, to the left anchor bar.
that the lower anchor connector hook is fully engaged by pulling hard
on the lower anchor connector strap.
4
WARNING
DO NOT use this child restraint if it moves more than 2.5 cm (1 in.)
side-to-side or front to back at the forward-facing belt path. Serious injury
or death may result from poor installation. If you can not tightly secure the
child restraint, try again, move it to another location, or install with the
vehicle seat belt.
Using your full weight, push the child restraint firmly into the
vehicle seat, while pulling up on the lower anchor connector
strap to tighten.
The lower anchor connector strap must be as tight as
possible. If you can move the child restraint more than 2.5 cm
(1 in.) side to side or front to back at the belt path, the lower
anchor connector strap is not tight enough. You will need
to try again, find another location for your child restraint, or
install with the vehicle seat belt (page 38). To remove the
lower anchor connector strap, go to page 50.
36
Quick Connector
Strap
Clip
Strap
Adjuster
DOUBLE CHECK
Forward-facing Installation with
Lower Anchor Connectors (cont.)
WARNING
5
• Failure to follow these instructions could result in
serious injury to your child or other vehicle occupants.
• The tether strap is for forward-facing use only.
WARNING
• To avoid a strangulation hazard, you
or fold excess tether strap and secure with the strap/
rubber band.
• Attach the tether hook to the storage clip when not in
use. This will keep an unused tether or tether hook from
hitting someone during a crash.
After adjusting the top tether strap, you may have
excess strap; DO NOT cut it off. If you do, it may not be
long enough to use in another vehicle. Instead, tightly
roll up the excess tether strap and place the rubber band
around the bundle.
Note: Refer to your vehicle owner's manual for the
location of the tether anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors that are
not addressed by the vehicle owner's manual or
answered by an authorized dealer/vehicle manufacturer,
call Evenflo's ParentLink at 1-800-233-5921 (U.S.)
or 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
Connect the tether hook
to the vehicle tether
anchor behind the vehicle
seat, as shown. (Please
consult your vehicle
owner's manual, as
tether anchor locations
may vary.) Pull the strap
and tighten the tether
securely.
MUST tightly roll
37