Charging By Connecting To A Computer - Sony ILCE-6500 Manual

Note
If the charge lamp flashes when the battery pack is not fully charged, remove the battery pack or
disconnect the USB cable from the camera and then re-insert it to recharge.
If the charge lamp on the camera flashes when the AC Adaptor is connected to the wall outlet (wall
socket), this indicates that charging is temporarily stopped because the temperature is outside the
recommended range. When the temperature gets back within the appropriate range, the charging
resumes. We recommend charging the battery pack at an ambient temperature of between 10°C to
30°C (50ºF to 86ºF).
Use a nearby wall outlet (wall socket) when using the supplied or recommended AC Adaptor/battery
charger. If any malfunction occurs while using this product, disconnect the plug from the wall outlet
(wall socket) immediately to disconnect from the power source. If you use the product with a charge
lamp, note that the product is not disconnected from the power source even when the lamp turns off.
When you use a completely new battery pack or a battery pack that has not been used for a long
time, the charge lamp may flash quickly when the battery is charged. If this happens, remove the
battery pack or disconnect the USB cable from the camera and then re-insert it to recharge.
Do not continuously or repeatedly charge the battery pack without using it if it is already fully charged
or close to fully charged. Doing so may cause a deterioration in battery performance.
When charging is finished, disconnect the AC Adaptor from the wall outlet (wall socket).
Be sure to use only genuine Sony brand battery packs, micro USB cables (supplied) and AC
Adaptors (supplied).
[14] Preparing the camera

Charging by connecting to a computer

The battery pack can be charged by connecting the camera to a computer using a micro USB
cable.
Turn off the product, and connect to the USB terminal of the computer.
1
Charging the battery pack