Devolo Magic 2 LAN1-1 Manual page 31

31 Configuration
ted by corresponding flashing behaviour regard-
less of this setting.
Powersaving
If Powersave mode has been enabled, the
devolo Magic 2 LAN
mode automatically whenever reduced data trans-
mission over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersave
devolo Magic 2 LAN
1-1
devolo Magic 2 LAN
1-1
switches to Powersave
mode is disabled
1-1
factory default settings.
Standby
If Standby
devolo Magic 2 LAN
Standby mode if no ethernet connection has been
enabled, i.e. if no network device (e.g. computer) is
switched on and connected to the network inter-
face and if Wi-Fi is disabled.
In this mode, the devolo Magic 2 LAN
accessible over the Powerline network. As soon as
the network device (e.g. computer) connected to
the network interface is switched on again, your
adapter can also be accessed over the electrical
wiring again.
Standby mode
devolo Magic 2 LAN
For information on the LED behaviour of the
devolo Magic adapter in standby mode, re-
fer to Chapter 2.3.1 Reading the indicator
light.
Firmware update
The currently installed firmware of the
devolo Magic adapter is displayed on the
overview page (see 4.2.1 Overview).
in the
mode is enabled,
1-1
automatically switches to
1-1
is enabled in
1-1
factory default condition.
the
is not
the