Page 1
MINIMAX BUMP SUPAIR-VLD PARC ALTAÏS 34 RUE ADRASTÉE User’s manual 74650 ANNECY CHAVANOD FRANCE English version 45°54.024’N / 06°04.725’ E RCS 387956790 Revision Indice: 10/11/2020...
Page 2
We trust that you will find this user’s manual comprehensive, explicit and hopefully pleasant to read. We advise you to read it carefully ! On our website www.supair.com, you will find the last up to date information about this product. If you have any further questions, feel free to ask one of our retailers.
Recycling Components Environmental friendly practices Carabiners assembly Warranty Bumpair assembly Disclaimer Position setting Pilot’s gear Pre-Flight control Service Book In flight Landing Wash and care of your harness Storage and transport Lifetime Care SUPAIR | MINIMAX BUMP | page 3...
After reading this manual, we suggest you check your harness by hanging in it before flying. N.B : Three important icons will help you when reading this manual Advice Caution ! Danger !! SUPAIR | MINIMAX BUMP | page 4...
EN 1651 - LTF Flight : tandem (Pilot- Passenger) Yes (Passenger) Flight : acrobatic flying Take-off : Winching Quick-out carabiners compatibility This harness is delivered with two 30 mm Biners ( 138 g. for the set ). SUPAIR | MINIMAX BUMP | page 5...
Place your left hand in front of and pass the risers to grab the right self-locking Biner. With the left arm, shorten the distance between the risers and pull the finger- loop in the opposite direction to loosen the chest strap. SUPAIR | MINIMAX BUMP | page 9...
• Fully close the leg straps, Safe-T-bar and chest strap buckles.. • Takeoff maintaining a vertical posture and push yourself inside the harness but only once away from the ridge. Do not let go the brakes when close to the terrain. SUPAIR | MINIMAX BUMP | page 10...
During high wind speed landings, turnaround and face the wing as soon as ground contact is made and move toward the wing while braking symmetrically to deflate it. Do not land in a seated position as it is dangerous. SUPAIR | MINIMAX BUMP | page 11...
- Ascertain parachute deployment functionality by pulling the handle to activate a clean POD extraction sequence. - Inspect the harness for wear and tear. Annual check - An annual deployment and repacking of the reserve parachute must be conducted by competent and certified personnel. SUPAIR | MINIMAX BUMP | page 12...
• The BUMPAIR integrity (especially after a strong impact ), in other words, no holes, tears or rips. The threads and fabric used to manufacture the MINIMAX BUMP were specifically selected for their quality and resilient capacities. However in particular instances such as long term UV exposure abrasion, contact with damaging chemicals, general wear and tear, the harness will need to be inspected at a professional certified repair facility.
If you estimate that your MINIMAX BUMP has reached the end of it life-span, you can separate plastics from metals and dispose of them according to your community recycling rules. As for the fabric itself contact your local authorities to find out how to proceed to discard it.
Entretien / Maintenance : 30°C If your BUMPAIR is damaged, have it inspected and repaired at a professional qualified facility or contact us at sav@supair.com The test results and the EU declaration of conformity can be found at: www.supair.com SUPAIR...
User manual | MINIMAX BUMP Service Book This page will help you to record all the life stages of your MINIMAX BUMP harness. Serial number : Purchase date Care Care Resale Resale Owner’s name Workshop’s name/ Buyer’s name Workshop’s name/ Buyer’s name...
Need help?
Do you have a question about the MINIMAX BUMP and is the answer not in the manual?
Questions and answers