General Safety Information - LG GEN2 Series Installation And Operation Manual

Gas Furnace PVF and PVG (for 112, 212, and 311 Chassis)
Model PVG
Model PVF

General Safety Information

These indirect gas-fired furnaces are commonly used
in many different manufacturer's ventilating products.
For unit-specific information, refer to the Installation,
Operation and Maintenance manual (IOM) for the unit in
which this furnace is installed.
•
Both the furnace units are listed for installation in the
United States and in Canada.
•
Installation of gas-fired duct furnaces must conform
with local building codes. In the absence of local
building codes, installation must conform to the
National Fuel Gas code, ANSI Z223.1 or in Canada,
CAN/CGA-B149 Installation codes.
•
All electrical wiring must be in accordance with the
regulations of the National Electric Code, ANSI/
NFPA-70.
•
Unit is approved for installation downstream from
refrigeration units. In these conditions, condensate
could form in the duct furnace and provision must be
made to dispose of the condensate.
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death or
property damage.
Be sure to read and understand the
installation,operation and service instructions
in this manual.
Recognized Component
Improper installation, adjustment alteration,
service or maintenance can cause serious
injury, death or property damages.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do
• Leave the building immediately.
• Immediately call your gas supplier from
• If you cannot reach your gas supplier,
— Installation and service must be
performed by a qualified installer, service
agency or the gas supplier.
WARNING
not use any phone in your building.
a phone remote from the building.
Follow the gas supplier's instructions.
call the fire department.