Operating Procedures - Uni-ram URS1600 Series User Manual

MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05

OPERATING PROCEDURES

Wear protective clothing in accordance with local safety and environmental regulations. Use face goggles
and gloves as a minimum. Use an apron and respirator if required.
Summary of Operating Steps:
1) Open the Safety Cover and Tank Lid
2) Install the Receiving Container, the Transfer Hoses and the air Supply
3) Transfer Solvent to the Recycler Tank. Fill to 3" below retainer ring.
4) Check distillation conditions and change, if necessary, using SETUP MODE
5) Recycling
6) Finish Recycling
7) Transfer clean solvent
8) Remove waste debris
9) Clean Distillation Tank and Lid Surface
10) Install new liner bag
11) Inspect Lid Gasket, Remove and Replace if necessary
Each Step is described in detail below.
1) Open the Safety Cover and Tank Lid
• Open the safety cover.
• Open the inner lid by releasing the Lid Clamp.
• Make sure that Tank is empty and that a Liner Bag is properly installed in the Tank.
TO OPEN, LIFT UP LID CLAMP AND RE-
LEASE LOOP. TO CLOSE, ATTACH LOOP
AND PUSH DOWN TO LOCK.
LID CLAMP
LOOP
6