Subscribe to Our Youtube Channel
Related Manuals for Uni-ram URS1600 Series
Summary of Contents for Uni-ram URS1600 Series
- Page 1 USER MANUAL URS1600 SERIES URS2000 SERIES & RI 80 URS2000 URS1600 UNI-RAM CORPORATION • ONTARIO • CANADA Revised 2019-05...
-
Page 2: Cautions And Warnings
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 CAUTIONS AND WARNINGS • The solvent recycler must be connected to the mains by a qualifi ed electrician with an explosion proof connection in compliance with applicable standards and regulations. -
Page 3: Features And Specifications
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 FEATURES AND SPECIFICATIONS All Uni-ram Solvent Recyclers feature rapid-start direct electric heating of solvent and a short cool- down time due to high-effi ciency condensers and air cooling with a motor driven fan. -
Page 4: Preparation And Setup
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 PREPARATION AND SETUP: • Carefully inspect the shipping carton for any sign of transport damage. • Carefully remove the unit from the shipping carton. • Check the unit for damage. Report any transport damage immediately to the carrier and your vendor. - Page 5 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 Solvents are heavier than air and accumulate near the fl oor. The area or room where the solvent recycler is located must have suffi cient natural or artifi cial ventilation to prevent the accumulation of solvent vapor air mixtures.
-
Page 6: Operating Procedures
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 OPERATING PROCEDURES Wear protective clothing in accordance with local safety and environmental regulations. Use face goggles and gloves as a minimum. Use an apron and respirator if required. - Page 7 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 2) Install the Receiving Container, the Transfer Hoses and the air Supply Receiving Container • A 20 US Gal (80 liter) container must be used to receive the distilled solvent. Make sure the Solvent Outlet Tube is properly inserted into the top opening of the Receiving Container by at least 1 inch (2.5...
-
Page 8: Step Setting
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 SETUP To change settings, enter Setup Mode: while pressing SETUP, press START. “SET-UP MODE” is dis- played. To change the temperature units from °C to °F, press and hold the + and - keys together for 2 seconds. - Page 9 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 5) Recycling On fi rst power up and on RESET, the Display Panel shows the Software Version, then: “READY S.P. = XXX°C” (S.P. = SET POINT). When Setup is complete and START has been pressed, the “HEAT”...
- Page 10 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 NOTE: If the bag sticks to the bottom of the tank, turn the recycler on for 5 minutes to loosen the bag from the bottom of the tank, then lift the bag out while the bag is warm.
- Page 11 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 THEORY OF OPERATION - DISTILLATION PROCESS Waste solvent consists of the original solvent plus liquid and solid materials picked up during use of the solvent. Recycling separates the original solvent from the waste materials. During the recycling process, the distillation tank fi...
-
Page 12: Troubleshooting Guide
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 TROUBLE SHOOTING GUIDE Carry out each action step until a solution is found. If the recommended actions do not solve the problem call Uni-ram Service in North America or contact a qualifi ed Service Technician. -
Page 13: Test Mode
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 PROBLEM CAUSE ACTION STEPS Solvent vapor leaks from the Lid 1) The Lid Gasket has 1) Replace the Lid Gasket (See Operating Gasket excessive wear as Procedure 11). -
Page 14: Error Messages
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 ERROR MESSAGES If an abnormal condition is detected by the unit’s Self-diagnostic System, the Display Panel shows one of the following error messages: MESSAGE POSSIBLE CAUSE... -
Page 15: Service Procedures
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 SERVICE PROCEDURES 1) CLEAN CONDENSER Remove the 2 screws at the back of the Side Cover and carefully move the Side Cover forward just enough to reach the front of the condenser with a vacuum. Using a brush attachment, vacuum the front of the condenser where most of the dust accumulates and then vacuum the back if necessary. - Page 16 MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 4) INCREASE LID TENSION (BY ADJUSTING THE SPRING BOLT) CAUTION: SHOULD BE DONE ONLY AS A LAST RESORT - FIRST CHECK FOR A WORN LID GASKET, A BLOCK- AGE IN THE SOLVENT FLOW PATH , LOOSE HINGE BOLTS OR A SET POINT THAT IS TOO HIGH FOR THE SOLVENT BEING RECYCLED.
-
Page 17: Replacement Parts
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05 REPLACEMENT PARTS DESCRIPTION PART NO. SAFETY COVER 960-3310H KEYPAD 900-3461 DIAPHRAGM PUMP UDP4TA RECEIVING CONTAINER 960-9010 LID GASKET, NEOPRENE, URS1600 790-2150NF LID GASKET, NEOPRENE, URS2000 965-2150N... - Page 18 “Conditions of Warranty” as consumables are not covered. Uni-ram reserves the right to direct the customer to ship the unit collect to the Uni-ram factory or to an ap- proved Service Center for repair using the Uni-ram Return Goods Procedure or to repair the unit on-site.
Need help?
Do you have a question about the URS1600 Series and is the answer not in the manual?
Questions and answers