Alesis Plus User Manual page 23

SELECTING THE RESONATOR CONFIGURATION
The Resonators are accessed through new Configuration 7, which is
RESONATOR->DELAY->REVERB. The block diagram of this configuration is as
follows:
FIGURE 3
CONFIGURATION 7
RESONATORS->DELAY->REVERB BLOCK DIAGRAM
RESONATOR CONTROLS:
Decay time Frequency
Resonator 1
Resonator 2
Resonator 3
L
Resonator 4
R
Resonator 5
To select this configuration, first press the
buttons until the display reads:
EDITING THE RESONATOR PARAMETERS
1) To access the Resonators parameters, press the
will then read:
This page determines if the resonators are gated by an incoming MIDI
note on/off. If the MIDI GATE is on, the input of each resonator will be
connected to the input signal only while its corresponding MIDI gate is on.
Consequently, when a note is released, the output of the resonator driven
by this note will decay to zero even if the input signal is active. Pressing
the buttons will select the MIDI GATED mode.
VALUE
DELAY TYPES
Mono Delay - 720ms
Stereo Delay - 320ms per side
Ping-Pong Delay - 320ms
1 2
MIX
DELAY
DELAY OUTPUT
RESONATOR
OUTPUT
button, then press the
CONFIG
CONFIGURATION:
RESONATOR>DL>REV
RESONATOR GATE
MODE: CONTINOUS
23
23
REVERB TYPES
Plate 1
Room 1
Chamber 1
Hall 1
Reverse 1
1 2
REVERB
MIX
REVERB OUTPUT
EFFECTS OUTPUT
DIRECT SIGNAL
button. The display
PITCH
L
R
VALUE