Alesis MultiMix8FireWire Quick Start Owner's Manual page 4

CHANNEL FEATURES
1. EQ: Boosts or cuts the respective frequencies for
each channel. When recording via Firewire, the EQ
settings ARE recorded.
2. AUX A: Routes channel signal to an external device
like an effects processor.
3. AUX B: Controls level routed to internal effects
processor or – if a device is patched into the Aux B
returns – routes channel signal to an external device
like an effects processor.
When recording via Firewire, the AUX A and B
signals are NOT recorded on the individual
channels. They ARE recorded via the MAIN MIX
channels.
4. PAN/BALANCE: Assigns the channel signal to
any spot in the mono or stereo spectrum.
When recording via Firewire, the MONO channels'
pan position is ignored when recording the
individual channel but is captured when recording
the MAIN MIX channels. The STEREO channels'
balance is captured by both the individual channel
and the MAIN MIX channels.
5. CHANNEL FADER: Controls the MAIN OUT
(analog) and Firewire (digital) signal level of the MIC
or LINE inputs.
MASTER FEATURES
Note: It is recommended that the MULTIMIX
FIREWIRE be turned off before connecting and
disconnecting any sources to the inputs of the unit.
However, do not turn off the MultiMix FireWire
once you have established a connection to the
computer.
1. AUX RETURN A: Controls the signal level that
returns from AUX A.
2. EFFECTS/AUX RET B: Controls the signal level
of the internal effects or the level returning from
AUX B if in use.
3. +48V LED: Indicates that the PHANTOM
POWER is enabled for the MIC inputs.
4. LED METERS: Monitors the audio signal level.
5. 2TK TO MIX: Routes the 2TK input as well as the
stereo return from the computer to the MAIN
faders.
6. 2TK TO CTRL: Routes the 2TK input as well as the
stereo return from the computer to the HDPH
/CTRL RM output.
7. MAIN MIX: Controls the level of the MAIN
OUTPUTS.
8. HDPH/CTRL RM: Controls the level that is sent to
the PHONES or CTRL RM outputs.