Robot Installation - Blaupunkt Bluebot Xtreme User Manual

Installation of mopping cloth | 2 in 1 electric-controlled water tank

Robot installation

1
Please do not move the charging base arbitrarily and keep it out
Robot installation Robot installation
of direct sunlight.
Connect the power line and feed the excess wire into the slot.
Starting up and charging
Paste the mopping cloth flat onto the bottom of
Long press to switch on the robot. Charge the robot on the
the water tank.
charging base when the power indicator light is normally on.
4
Remove the mopping module
When the robot is finished working, press • If the machine cannot be started due to a low battery
• If the charging base is relocated, the host may fail in positioning and lose the map. When restarted, the host will rebuild and memorise the • Ensure a space of more than 1 m on both sides of the charging base and a space of more than 1.5m in the front.
charge, please charge the host on the charging base and
the button in the middle of the water tank
• If the power line is vertical to the ground, it may be dragged by the host and consequently, the charging base may be powered off. map and the rebuilt map may lose the cleaning information regarding forbidden areas and other areas
the machine will start automatically. The machine can
to remove the mopping module backwards,
• Direct sunlight will interfere with the recharging signal and consequently, the host may be unable to return to the charging base • The charging indicator is normally on when powered on and off when charged.
only work normally when the battery level is ≥20%.
empty the water in the water tank and clean
the mopping cloth (do not move or turn the
robot over during cleaning).
PRODUCT INTRODUCTION INSTALLATION
2
Fill the water tank: uncap the cover and fill
with water.
Instructions for mopping module
1. Please do not use the mopping module after it has been left unused.
2. For the sake of safety, please be sure to remove the mopping module when it is being
charged or left unused.
3. Please do not mop the carpet. Set a forbidden area in the APP to prevent the machine from
going onto the carpet.
Robot
4. To achieve a better mopping effect, the mopping module should be installed after sweeping
the floor three times.
5. To add water or clean the dust cloth when the machine is working, please pause it, and take
out and reassemble the mopping module according to steps 8 and 9. Please do not move
or turn the host over, otherwise, it could fail in its positioning, lose its map and "forget" the
forbidden areas that are programmed.
6. The mopping function of the machine is intended for wiping and is conducive to deep
cleaning. It cannot remove stubborn stains effectively and replace the labour force.
APP INSTALLATION
3
Make the left-side brush (L) and the right-side brush (R)
correspond to L and R on the bottom casing, press L and R and
the side brushes are installed till you hear a "cracking" sound.
Start cleaning Place the charging base against the wall and connect the power.
Press and hold the button in the middle of the
After the robot is powered on, short press key on the robot
tank and push it horizontally along the rear
R
or use the mobile APP to start cleaning (press any button to
of the robot. The module is installed in place
pause during use).
correctly if you hear the sound of a "click".
• The sweeping robot cannot be used to remove liquids.
• If the battery level is less than 20%, the machine will not
>1 m
work. Please charge it.
• The machine will return to the charging base
>1.5m
automatically if the battery level is less than 20% when
in use and will be powered off and then start cleaning
Mopping module
automatically after the battery level reaches 80%.
• Please clear various wires (including the power line of
the charging base) from the ground before use to avoid
outage and damage of objects or wires when wires are
dragged by the host.
APP INSTRUCTIONS INSTRUCTIONS
Back
L
>1 m
DAILY MAINTENANCE OTHERS