Getting Started - Vax Platinum PowerMax Let's Get Started

GETTING STARTED

PLEASE READ THE SAFETY PRECAUTIONS ON PAGES 2 & 3 BEFORE USE.
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing.
• Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/rugs/
upholstery, gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white paper
towel or cloth. Check all carpets/rugs/upholstery material before first use and if your carpet has more than one colour,
check all colours.
• Test all flooring/carpets/rugs before first usage. Run the machine over a small hidden area. If no damage or pile distortion
occurs continue cleaning.
• When using the machine, basic safety precautions should always be observed. Do not over saturate your carpets and
continue using dry strokes until little water is visibly passing through the nozzle. When using the hose and tools always
finish on a dry stroke.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture cannot be moved, place
aluminium foil or wax paper under the legs. This will prevent wood finishes from staining your carpet. Pin up furniture
skirts and curtains.
• Only use VAX carpet solution. Using other solutions may cause excess foaming and will invalidate the guarantee.
• For heavily soiled areas, it may be necessary to repeat the cleaning process. Make criss-crossing strokes across the
original pattern and overlap with each pass.
• The clean water tank should only be filled with warm water (max 40�C). Filling the clean water tank with hot/boiling water
will damage your machine and invalidate the guarantee.
• Empty and rinse out clean and dirty water tanks and leave to air dry before storage. Do not leave solution stored in the
tanks between uses.
• This is a powerful machine, before plugging in make sure all controls are turned off and hold the machine firmly when
starting and during use.
Assembly
Stand the base of the
machine on the floor in the
upright position. Line up the
handle with the main body
and push into place.
Line up the SpinScrub tool
with the holder and slide the
tool downwards into place.
8
Turn the handle lock dial
clockwise to lock in position.
Assemble the tanks by tilting
and lining up the front of
the tank to the washer and
pushing the tank back until
it clicks into place.
Slide the SpinScrub tool
holder over and down
the handle.