Operating The System; Switching On / Off; Open Sleep Function - Ten-Haaft Oyster CYTRAC DX Premium Instructions For Use Manual

2. OPERATING THE SYSTEM

2.1 Switching on / off

Before using the satellite antenna:
Please make sure that the view towards the south is free of obstacles (no trees, high buildings, or mountains,
etc.). Make sure there is enough space above the antenna to ensure unobstructed antenna movements. It may be
possible that certain roof hatches on some motorhomes need to be closed, otherwise the antenna could collide
with them.
Switch on the Oyster® TV in the operating mode "DVB-S" or "Satellite" and select the desired TV programme. The
antenna will run out and newly orient itself automatically to the satellite on which your desired TV programme
can be received. As soon as you select a programme from another satellite, the antenna will automatically align
itself with the new satellite. If the Oyster® TV is switched off again, the antenna automatically runs in again.
You do not have to take care of anything else. However, if desired, automatic running in of the antenna can be
deactivated case on case by the Open Sleep function.
Additional information for Twin or Quad systems:
In vehicles with two or more TV sets, there is always one main set. Only this main set is connected to the satellite
system's control unit, and it can send commands to the antenna via the control device. All other TV sets on board
are connected to the actual antenna, but not to the control unit. For this reason it is not possible to control the
antenna with any other than the main set.
- Example 1: The main TV set is switched on, the antenna is run out, and all TV sets on board are working. Now
the main TV is to be switched off but one or more of the other TVs are to continue to be operated. When the main
TV set is switched off, however, the antenna is automatically run in and the other TV sets do no longer have a
signal. The automatic run-in of the antenna can be deactivated by activating the Open Sleep function explained
below, see item 2.2 Open Sleep.
- Example 2: The antenna is run in, the main TV set is switched off, and you want to start one of the other
TV sets directly. Please use the "ten Haaft® App" or the left button on the control unit for the satellite system
(FeatureBox) to run out the antenna. It remains run out until either the main TV set has been switched on and
off again, the vehicle engine has been started, or the app or the button on the control unit (FeatureBox) have
been operated again.
6
2. OPERATING THE SYSTEM

2.2 Open Sleep function

A STOP button is on the remote control for your Oyster® TV set. To activate Open Sleep, press the STOP button
shortly before switching off the main TV set with the red POWER button (button sequence "Stop" - "Power"). This
only switches off the main TV set and the antenna remains run out and active.
The next time the main TV set is switched on, it takes control of the antenna again. The next time the main TV
is switched off, the antenna will run in automatically unless you activate Open Sleep again by pressing the STOP
button.
Even with activated Open Sleep, the antenna will be run in automatically at the latest when the vehicle engine
is started.
For safety reasons, the system must run in when the ignition of the vehicle is operated. To activate the antenna
again, it is necessary to restart the "Oyster® TV" Premium device (use the remote control to switch it off and on
again) with the car engine switched off, or to use the alternative operating method via the App or the left button
of the control unit (FeatureBox).
7