Vixen AP Equatorial Mount Instruction Manual page 63

APPLICATION
6
Turn the R.A motor module to change the orientation so that the
screw holes (larger holes with no thread) are aligned in tandem. Re-
place the the three socket head cap screws in place and tighten the
screws securely with the 3mm Allen wrench.
7
Attach the declination body onto the polar axis body assembly so that
the electrical contact on the declination body fits the counterpart on
the R.A motor module as shown in the figure.
8
Replace the two socket head cap screws that were removed in step
3 above while holding the declination body. Install the batteries, if
necessary. Tighten the screws with the Allen wrench of 4mm on a side
securely.
9
Replace the declination body cover in place noting the direction of the
hook on the cover.
R.A motor module R.A motor module
Declination body Declination body
Electrical contact Electrical contact
4mm 4mm
Allen wrench Allen wrench
Declination body cover Declination body cover
63
3mm 3mm
Allen wrench Allen wrench
Declination Declination
body body
Declination body Declination body