Vixen AP Equatorial Mount Instruction Manual page 59

APPLICATION
6
Turn the manual slow motion control module so that the screw holes
(larger holes with no thread) are aligned in tandem. Replace the three
socket head cap screws in place.
Tighten the screws with the 3mm Allen wrench securely.
7
TAttach the declination body assembly onto the polar axis body
assembly so that the electrical contact on the declination body fits
into the sunken portion on the manual slow motion control module
as shown in the figure.
8
Replace the two socket head cap screws that were removed in step
2 above while holding the declination body. Install the batteries, if
necessary. Tighten the screws with the 4mm Allen wrench securely.
9
Replace the declination body cover (battery compartment cover)
with attention to the direction of the hook on the cover.
Manual slow motion Manual slow motion
control module control module
Declination Declination
body body
Electrical Electrical
contact contact
Sunken portion Sunken portion
Declination body Declination body
4mm Allen wrench 4mm Allen wrench
Declination body cover Declination body cover
59
3mm 3mm
Allen wrench Allen wrench
Declination Declination
body body