Troubleshooting - Concept2 VP9241 Operating Instructions Manual

EN
AIR INLET FILTER CLEANING AND REPLACEMENT
1. Disconnect the fl exible hose and open the appliance's cover.
2. Remove the air outlet fi lter (Fig. 6). This type of vacuum cleaner is equipped with
an H.E.P.A. fi lter in the outlet, which is capable of retaining very tiny dust particles.
You can clean this fi lter by tapping and shaking, and then with a soft brush. After
this operation is complete, you can clean a very dirty fi lter by washing and rubbing
with a soft brush in lukewarm water without any cleaning agents added. Note: Do
not use a washing machine for washing the fi lter. It is very important to let the wet
parts dry thoroughly. A wet fi lter would get damaged by suction! Do not use a
hair dryer for drying the fi lter!
Note: Wet cleaning may cause more wear and tear of the fi lter and, consequently,
shorten its service life.
3. Insert the cleaned or new air outlet fi lter into the appliance and close the air outlet
grid.

TROUBLESHOOTING

Problem
The motor does not run.
The motor has stopped
working.
Front cover cannot be
closed
The suction power is
reduced.
The appliance gets warm.
VP9241
Cause
The plug is inserted into the
outlet incorrectly or insuffi ciently.
The outlet is not live.
The air fl ow is improper or too
low and, consequently, the motor
overheat fuse has been activated.
The dust retention bag is inserted
incorrectly.
The dust retention bag is full or
clogged.
The fi lter is clogged.
The attachment, the tube, or the
hose are clogged.
The appliance warming during its operation is normal, it is not a fault.
Fig. 6
Resolving
Check the plug connection.
Check whether the voltage is present by
using another appliance.
Disconnect the power supply cable from
the outlet. Check and release the air suction
and discharge passages, the fi lters for dirt, or
replace the dust retention bag.
Let the appliance cool down.
Check the dust retention bag for proper
fi xing.
Replace the dust retention bag.
Clean or replace the fi lter.
Check and clear the air suction
and discharge passages.
29