Dyna-Glo DGU732BDE Manual page 14

OPERATING INSTRUCTIONS
Safety Guidelines
• Refer to the "Troubleshooting Section" on Pages 22 and 23 for operational problems.
• DO NOT open the smoker door while operating, unless it is necessary. Opening the door will allow
heat to escape and prolong the cooking time.
• DO NOT USE CHARCOAL. This appliance is not designed for use with charcoal or similar
combustible fuels and a fire will result if charcoal is used during operation. The fire will create an
unsafe condition and damage the smoker.
• Although wood chips are not required for operating the smoker, they should be used during the
cooking process to create the smoke needed for adding flavor.
• In order to maintain optimal performance, cleaning the smoker after each use is highly
recommended. Wait until the smoker has completely cooled before cleaning. Refer to the
Care and Maintenance section on Page 21.
CONTROL PANEL OPERATING INSTRUCTIONS
– Turns smoker on and off
– Switches input to adjust cooking temperature.
– Switches input to adjust cooking time. Switches between F and C when held for 5 seconds.
– Displays the meat temperature, when pressed.
– Indicates that the smoker is plugged in and ready to turn on, when lit.
– Indicates the burner is ON, when lit.
• Press the Power Button ( ) once (a beep should occur). The display will switch between 00:00
and the internal temperature (F or C) every few seconds until the control panel receives the input
settings for Temp Button ( ) and/or Time Button ( ).
NOTE: Although water is not required during the cooking process, always leave the water bowl in
place while operating the smoker. If additional water is needed during the cooking process, carefully
pour water into the water bowl. DO NOT remove the water bowl to add water. Avoid splashing water
onto the heating element. Serious damage to the heating element could result, along with flare-ups
and electrical failure.
00:00
14