Front Seat Support Installation; Rear Seat Support; Rear Seat Support Removal; Rear Seat Support Installation - Pioneer 1200 Maintenance Service Manual

BODY AND TRIM
4. Remove four hex-head bolts (8), eight washers (9) and four lock nuts (10) from the seat support
(Figure 4-3, Page 4-6).
5. Remove the two armrests (11 and 12) from the seat support (1).
6. Lift seat support (1) from vehicle.

FRONT SEAT SUPPORT INSTALLATION

1. Reverse the front seat support removal process (Figure 4-3, Page 4-6).
2. Assemble bolts (8), washers (9), and lock nuts (10) to seat support and armrests (11 and 12) and tighten
bolts (8) to 13 ft-lb (17.6 N·m). See following WARNING.
∆
WARNING
• Both armrests must be installed before operating the vehicle, unless the vehicle is fitted with
a structural cab.
3. Connect differential lock cable to differential lock handle. See step 33 of Unitized Transaxle Installa-
tion, Section 16, Page 16-22.
4. Install park brake equalizer cable. See Equalizer Cable Installation, Section 6, Page 6-34.
5. Install both front seats (2) onto the vehicle.

REAR SEAT SUPPORT

See General Warning, Section 1, Page 1-1.

REAR SEAT SUPPORT REMOVAL

1. Lift rear seat cushion and remove from the vehicle.
2. Remove eight 1/4-20 flange lock nuts (21) and eight 1/4-20 x 3/4-inch carriage bolts (20) and remove arm
rests (10 and 11) (Figure 4-4, Page 4-8).
3. Remove four 1/4-20 x 1 inch, phillips drive, truss-head machine screws (19) and lock washers (18) from
seat back support (22) and remove seat back (16) and seat back cap (17).
4. Remove four 5/16-18 flange lock nuts (24) and four 5/16-18 x 3/4-inch carriage bolts (23) and remove
seat back support (22).
5. Remove seat bottom rear trim (13) by pushing-out, from the back of the seat back support (22), five plas-
tic barrel connectors (12).
6. Remove the seat bottom front trim (14) by lifting the lower inside flange slightly across the entire seat
area. Push the trim toward the rear of the vehicle, allowing the top flange to slide away from the seat
frame toward the rear of the vehicle.

REAR SEAT SUPPORT INSTALLATION

1. Slide the seat bottom front trim toward the front edge of the seat frame with the top flange of the trim slid-
ing over the top of the frame. Push toward the front of the vehicle until the lower flange snaps into place.
The top and bottom flanges of the trim should be in direct contact with the frame structure.
2. Install the seat back support (22) in reverse order of removal. Tighten hardware to 15 ft-lb (20.34 N·m).
3. Install a new seat bottom rear trim using new barrel connectors.
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
4
Rear Seat Support
Page 4-7